LG STEAM WASHER Guía Del Usuario E Instrucciones De Instalacion página 36

O P T I O N A L AC C E S S O R I E S
PEDESTAL INSTALLATION
3
Make sure the back feet are in the correct
positions.
The washer feet will fit into the outermost
corner positions and the dryer feet will fit into
the innermost positions as shown.
Raise
Loosen the locknuts on all 4 leveling feet
5
of the pedestal until you can turn them
with the wrench. Turn clockwise to raise or
counterclockwise to lower until the pedestal
is level and all 4 feet are solidly against
the floor.
Using the Floor Pads
When installing the pedestal on a wooden
floor, place the included floor pads under the
legs of the pedestal. This will help reduce
vibration when the washer is operating.

(cont.)
4
Lower
6
Make sure the holes on the pedestal align
with the holes in the appliance, then install 4
screws at each corner to securely attach the
appliance to the pedestal.
NOTE: If the screws are not installed
properly, noise and vibration may result.
Move the appliance to the desired location.
Locknut
Securely tighten all locknuts by hand.
NOTE: Noise and vibration may result if
locknuts are not tightened.
Be sure to connect the appliances to all
water, power, or gas lines and draining or
venting connections before operation.
If there is excessive vibration during the
first operation after installation, slightly
adjust the leveling feet.