Mounting Precautions - Sharp PN-L705H Manual De Instalación

• This product is for use indoors.
• A mounting bracket compliant with VESA specifications is
required.
• Since the monitor is heavy, consult your dealer before
installing, removing or moving the monitor.
• Mounting the monitor on the wall requires special expertise
and the work must be performed by an authorized SHARP
dealer. You should never attempt to perform any of this
work yourself. Our company will bear no responsibility
for accidents or injuries caused by improper mounting or
mishandling.
• Use the monitor with the surface perpendicular to a level
surface. If necessary, the monitor may be tilted up to 20
degrees upward.
• When moving this monitor, hold with the handles or at
the sides of this monitor, and hold the top and bottom of
this monitor. Do not grasp the screen, monitor corner,
tray, speaker, or speaker cover. This may cause product
damage, failure, or injury.
• This monitor should be used at an ambient temperature
between 41°F (5°C) and 95°F (35°C).
• Be careful of high temperatures in the surrounding area.
If it is difficult to provide sufficient space for any reason
such as the installation of the monitor inside a housing, or
if the ambient temperature may be outside of the range
of 41°F (5°C) to 95°F (35°C), install a fan or take other
measures to keep the ambient temperature within the
required range.
• Temperature condition may change when using the monitor
together with the optional equipments recommended by
SHARP. In such cases, please check the temperature
condition specified by the optional equipments.
• Do not block any ventilation openings. If the temperature
inside the monitor rises, this could lead to a malfunction.
• Do not place the monitor on a device which generates heat.
• Adhere to the following when installing the monitor in its
portrait orientation. Failing to adhere to the following may
cause malfunctions.
- Install the monitor such that the power LED is located on
the bottom side.
- Set the PORTRAIT/LANDSCAPE INSTALL on the
MONITOR menu to PORTRAIT.
(See OPERATION MANUAL.)
4
E

MOUNTING PRECAUTIONS

Power LED
- Be sure to clamp the power cord (supplied) onto the cable
clamp attachment using the supplied cable clamp. When
clamping the power cord, take care not to stress the terminal
of the power cord. Do not bend the power cord excessively.
Cable clamp
attachment Cable clamp
Power cord (Supplied)
• Use the supplied vertical sticker when you install the
monitor in portrait orientation.
Flat installation
• When using the monitor laying flat on a surface (when the
monitor is tilted more than 20 degrees upward from the
perpendicular in relation to a level surface), consult an
authorized SHARP dealer because there are some specific
mounting conditions.
Adhere to the following. Failing to adhere to the following
may cause malfunctions.
- Set HORIZONTAL INSTALLATION in the MONITOR
menu to UPWARD. (See OPERATION MANUAL.)
- Use the monitor at the ambient temperature within the range
of 41°F (5°C) to 86°F (30°C). Provide 7-7/8 inch (200 mm)
or more space between the monitor and the floor or other
mounting surfaces and surrounding objects to prevent heat from
accumulating inside. If it is difficult to provide sufficient space or
if the ambient temperature may be outside of the range of 41°F
(5°C) to 86°F (30°C), install a fan or take other measures to
keep the ambient temperature within the required range.
7-7/8 [200]
7-7/8
[200]
7-7/8 [200]
- Do not press hard on the LCD panel or otherwise subject
it to impacts.
Cover SHARP logo
Logo
Unit: inch [mm]
7-7/8
[200]
7-7/8
[200]