Get-Function Listing - ViewSonic CDM4300R Guia Del Usuario

Mute 8
Button Lock 8
Menu Lock 8
Key Pad 8
Remote Control 8
Factory reset 8

10.3.2. Get-Function Listing

The PC can interrogate the TV/DS for specific information. The Get-Function packet format consists of 9
bytes which is similar to the Set-Function packet structure. Note that the "Value" byte is always = 000
Get-Function description:
Length: Total Byte of Message excluding "CR".
TV/DS ID Identification for each of TV/DS (01~98; default is 01).
Command Type Identify command type,
"g" (0x67h) : Get Command
"r" (0x72h) : Valid command Reply
"-" (0x2Dh) : Invalid command Reply
Command: Function command code: One byte ASCII code.
Value[1~3]: Three bytes ASCII that defines the value.
CR
0x0D
Get-Function format
Send: (Command Type="g")
Name Length
Byte Count 1 Byte
Bytes order 1
NOTE: "Power STBY status" is the exception for VT2405LED-1 and VT3205LED.
s 6
s 8
s >
s A
s B
s ~
Command
ID Command
Type
2 Byte 1 Byte
2~3 4
36 000: OFF
001: ON (mute)
38 000 : Unlock
001 : Lock
3E 000 : Unlock
001 : Lock
41 000 : UP
001 : DOWN
002 : LEFT
003 : RIGHT
004 : ENTER
005 : INPUT
006 : MENU/EXIT
42 000: Disable
001: Enable
002: Pass through
7E 0
Value1
1 Byte 1 Byte
5 6
48
Disable: RCU has no
effect on Monotor.
Enabled: RCU controls
the Monitor. This is the
power up default on the
Monitor.
Pass through: RCU
has no effect on
Monitor and all RCU
command codes are
transmitted to PC via
the RS232 port.
Rests Monitor to
factory setting
Value2 Value3
1 Byte 1 Byte
7 8
CR
1 Byte
9