Tramontina AP700 Manual De Uso Y Mantenimiento página 14

Form of usage
Keep the switch pressed down and lift the trimmer about 3 cm from the ground. In this position move slowly
the trimmer from one side to another to promote the trimming of the grass.
Never use the trimmer without the protector or when it is damaged, since the protector helps in the refrigeration
of the motor, limits the length of the nylon string and is a safety device for the operator.
It is recommended to give an interval for rest of 2 minutes after 15 minutes of continuous use, thus ensuring
greater useful life to the motor and thus preventing an overload.
This equipment is recommended for occasional (use domestic) use in lawns of up to 100 square meters,
!
to do the outlines, edges and corners. The area may be larger or smaller depending on conditions of use:
type of grass, height of grass, the temperature, humidity, etc.
Do not use on humid or wet grass.
Do not overload the trimmer by entering into tall grass. If needed, carry out several cuts starting on top
!
and going down to smaller cuts.
Inspect and perform maintenance regularly on the trimmer. Any maintenance must be performed by an
authorized technician.
!
For any maintenance and control operation, the electric cable must be disconnected from the outlet.
Spool refill
Keep the spool housing (1) fixed and turn the top cover of the spool (2) in the counterclockwise direction [Fig. 7, Pag. 06].
Remove the used spool (3) and place the new spool, causing the string to pass through top cover output opening
of the spool [Fig. 8, Pag. 06].
Then replace the assembly top cover and spool (4) pressing it against the spool housing (1), and turning it in the
clockwise direction until the latch snaps [Fig. 09, Pag. 06].
Nylon string reload
Use only nylon string in the recommended diameter 1.8 mm and length of 8 meters.
The spool can be reloaded, as follows
Fit the string into the spool opening (1) according to figure [Fig. 10, Pag. 06].
Coil the string in the direction indicated by the reel's arrow (2), [Fig. 11, Pag. 06] as uniformly as possible, obeying
8 metres as the maximum length recommended.
The use of the equipment without the nylon string outside of the recommended diameter, is considered as
warranty loss.
Replacement parts
It is recommended that the replacement parts and nylon string spools are of the same model and brand Tramontina.
The string used in the spools is special for this function.
Nylon string adjustment
Manual
Keep pressed down the button (1) of the spool [Fig. 12, Pag. 07] pull the nylon string up to the cutting blade of
the protector. Then release the spool button and the nylon strings so that the spool may automatically be adjusted
to its housing
13
MAINTENANCE