Technical Data - Facom CL3.CH18S Manual Original

Speed Selector (fig. 1)
Your tool is equipped with a speed selector (i) which allows you to select one of three speeds. Select the speed based on the application and control
the speed of the tool using the variable speed trigger switch (a).
Anvil (fig. 2)
WARNING: Use only impact accessories. Non-impact accessories may break and cause a hazardous condition. Inspect accessory prior to use
to ensure that it contains no cracks.
CAUTION: Inspect anvils, detent pins, and hog rings prior to use. Missing or damaged items should be replaced before use.
Place the switch in the locked off (center) position or remove battery pack before changing accessories.
ANVIL WITH DETENT PIN
To install an accessory on the anvil, align the hole in the side of the accessory with the detent pin (h) on the anvil (c). Press the accessory on until
the detent pin engages in the hole. Depression of detent pin may be necessary to aid installation of accessory.
To remove an accessory, depress the detent pin through the hole and pull the accessory off.
ANVIL WITH HOG RING
To install an accessory on the hog ring anvil, firmly push accessory onto the anvil (c). The hog ring (h) compresses to allow the accessory to slide
on. After accessory is installed, the hog ring applies pressure to help provide accessory retention.
To remove an accessory, grasp the accessory and firmly pull it off.
Usage
Your impact tool can generate the following maximum fastening torque: 950 N.m
WARNING: Ensure fastener and/or system will withstand the level of torque generated by the tool. Excessive torque may cause breakage
and possible personal injury.
1. Place the accessory on the fastener head. Keep the tool pointed straight at the fastener.
2. Press switch to start operation. Release switch to stop operation. Always check torque with a torque wrench, as the fastening torque is affected
by many factors including the following:
Voltage VDC
Type
Battery Type
No load speed
Impact rate
Max fastening Torque N.m
Max breakaway Torque N.m
Weight (without battery pack) kg
NU-CL3.CH18S_1016.indd 24
Speed 1 0–400 rpm
Speed 2 0–1200 rpm
Speed 3 0–1900 rpm

TECHNICAL DATA

CL3.CH18 S
18V
3
Li-Ion
0-400
0-1200
0-1900
0-2400
950
1625
2,6
24
10/10/2016 14:53:46