Safety Instructions; Safety Data - Facom Y.135F Guía De Instrucciones

TO INSURE PROPER FUNCTIONING AND SAFE OPERATION READ THIS MANUAL CAREFULLY BEFORE SETTING UP OR
OPERATING THE FACOM Y.135F TOOL.
1. DO NOT use this tool in a manner other than that recommended by FACOM.
2. Always wear eye protection when using or when near a tool that is in use.
3. This tool is NOT designed for use in explosive atmospheres.
4. Inspect tool for damage before connecting to air supply including all air connections.
5. Trained personnel must perform tool repair and/or maintenance at the prescribed intervals.
6. Disconnect the air supply when adjusting, servicing or removing any part of the tool.
7. Keep fi ngers off the trigger when connecting the air supply or if the air supply fails.
8. Keep fi ngers away from the front of the tool when connecting the air supply or setting rivets.
9. DO NOT point the tool at anyone.
10. DO NOT operate tool with the nose housing removed.
11. DO NOT operate tool without the Defl ector or Collector.
12. DO NOT modify the tool in any way. Modifi cation will make void any applicable warranties
and could result in damage to the tool or physical injury to the user.
13. DO NOT look into the tool from the front or the back during use or when connected to air supply.
14. The operating pressure must not exceed 100 psi (6.9 bar).
15. DO NOT direct tool exhaust towards anyone.
16. Wash hands if exposed to hydraulic fl uid or lubricant.
17. Keep hair, fi ngers and loose clothing away from moving parts of the tool.

SAFETY DATA

First Aid:
SKIN:
Remove contaminated clothing and shoes and wipe excess from skin. Flush skin with water, then wash with soap and water.
If irritation occurs, get medical attention.
INGESTION:
Do not cause a vomiting. In general, no treatment is necessary unless large quantities of product are ingested.
However, get medical attention.
EYES:
Flush with water. If irritation occurs, get medical attention.
Fire:
FLASH POINT: 390°F/198.9°C
Material will fl oat and can be re-ignited on the surface of water. Use water fog "alcohol foam" dry chemical or carbon dioxide (CO2) to
extinguish fl ames. Do not use a direct stream of water.
Environment:
SPILLAGE:
Soak up residue with an absorbent such as clay, sand or other suitable material. Place in a non-leaking container and seal tightly for
proper disposal.
HANDLING:
Wash with soap and water before eating, drinking, smoking, applying cosmetics or using toilet. Properly dispose of leather articles such as
shoes or belts that cannot be decontaminated. Use in a well ventilated area.
STORAGE:
Store in a cool, dry place with adequate ventilation. Keep away from open fl ames and high temperatures.

SAFETY INSTRUCTIONS :

BAR
10