Installing Your New Power Supply - BE QUIET! Pure POWER L8 Serie Manual De Usuario

Voltage stability:
The Pure Power Series has first class stability in its voltage supply. This is
guaranteed by the high quality of its component parts. Output voltages are
therefore maintained at the optimal set value, which is particularly important with
high performance specifications.
Fuse functions:
be quiet! Pure Power power supplies offer high safety with many fuse functions.
The power supply automatically switches off if limits are exceeded or not reached.
OCP (over-current protection, UVP (under-voltage protection), SCP (short circuit
protection), OPP (over power protection), OTP (over temperature protection),
OVP (overvoltage protection). If the power supply is operated at an excessively
high temperature, it will automatically switch off. It can then be switched on after
cooling off. Please ensure that the PC is equipped with sufficient cooling.
5.

INSTALLING yOUR NEW POWER SUPPLy

You must read the item „Warnings/safety instructions" before beginning
installation. You will need a screwdriver to fit the power supply in your PC.
Only use the screws supplied with the power supply, as these have the suitable
thread.
First remove your old power supply. To do this, proceed as follows:
1. Carefully disconnect your PC from any power sources and pull out all cables
connected to the PC.
2. Open the PC case also following the manufacturer's instructions.
3. Disconnect all plugs from the motherboard and all other components, such as
an FDD, HDD or optical drives. Ensure that there are no plugs from the old power
supply connected to any of the components.
4. N ow remove the screws on the rear of the power supply and take it out carefully.
Make especially sure that no cables get caught in the components and damage
them.
13