Metra 108-FD6CH Instrucciones De Instalación página 3

7. Unclip the shifter trim bezel and slightly
pull it up to clear the center console trim
bezel removal.
8. Open the center console storage
compartment. Unclip the center console
trim bezel, then slide it toward the rear
of the vehicle to remove it. (Figure G)
Note: The complete center console does
not need to be removed. but if it is
desired to be removed, the Push-to-
Start module must be connected when
testing the kit.
9. Remove the plastic tray in front of the
shifter.
10. Remove the center plastic trim
(knockout) between the power outlet
and USB jack. (Figure H)
DASH DISASSEMBLY
(Figure G)
(Figure H)
(CONT.)
Ensure that the vehicle is completely
off before proceeding onto the
following (3) steps:
11. Remove the (4) 9/32" screws securing
the radio/climate control panel, and then
unclip, unplug, and remove. (Figure I)
12. Remove the (4) 9/32" screws securing the
display screen, then unplug and remove.
(Figure J)
13. Remove the (4) 9/32" screws securing the
radio chassis, then unplug and remove.
(Figure J)
Continue to Kit Preparation
(4.2" screen shown for illustration only)
(Figure I)
(4.2" screen shown for illustration only)
(Figure J)
REV. 9/25/2019 INST108-FD6CH
3