Final Assembly; Programming - Metra 108-FD6CH Instrucciones De Instalación

PROGRAMMING

1. Refer to step 2 from the Installation section.
2. Press the push-to-start button to start the vehicle.
Note: If the Push-to-Start module in the center console has been disconnected, reconnect it.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type.
b. Wait until the radio comes on, and the touchscreen display shows SWC Configured.
This process may take up to 3 minutes.
Note: If the touchscreen display doesn't load up, or the radio doesn't come on within
3 minutes, and/or the touchscreen display doesn't show SWC Configured, check all
connections, then reset the interface and try again. Refer to the Troubleshooting section.
4. Cycle the key off. If the driver's door is closed, open and close the door. Cycle the key back on.
5. Test all functions of the installation for proper operation, before reassembling the dash.

FINAL ASSEMBLY

1. Connect the USB cable attached to the radio trim panel, to the USB port in the
back of the radio.
2. Secure the completed assembly into the upper dash using the factory hardware removed in
step 12 of dash disassembly.
3. Snap the radio trim panel over the completed radio assembly, then reassemble the
dash in reverse order of disassembly.
11
REV. 9/25/2019 INST108-FD6CH