Functional Description - Makita HR2631F Manual De Instrucciones

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
1
2
015336
015360
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop. For
continuous operation, pull the switch trigger, push in the
lock button and then release the switch trigger. To stop
the tool from the locked position, pull the switch trigger
fully, then release it.
Lighting up the lamps
For Model HR2631F, HR2631FT
CAUTION:
Do not look in the light or see the source of light
•
directly.
1. Switch trigger
2. Lock button
1. Switch trigger
2. Lock button
2
1
1
015337
To turn on the lamp, pull the trigger. Release the trigger
to turn it off.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
Do not use thinner or gasoline to clean the lamp.
•
Such solvents may damage it.
Reversing switch action
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
For Model HR2631F, HR2631FT, HR2630, HR2630T
CAUTION:
If the switch trigger can not be depressed, check
•
to see that the reversing switch is fully set to
position (A side) or
1
015338
This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to
the position (A side) for clockwise rotation or
the position (B side) for counterclockwise rotation.
5
1. Lamp
(B side).
1. Reversing
switch lever
B
A