Makita HR2631F Manual De Instrucciones página 9

Dust cup (optional accessory)
1
010731
Use the dust cup to prevent dust from falling over the
tool and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in
the figure. The size of bits which the dust cup can be
attached to is as follows.
Dust cup 5
Dust cup 9
006386
There is another type of dust cup (optional accessory)
which helps you prevent dust from falling over the tool
and on yourself when performing overhead drilling
operations.
Installing or removing the dust cup
(optional accessory)
1
3
015351
Before installing the dust cup, remove the bit from the
tool if installed on the tool. Install the dust cup (optional
accessory) on the tool so that the
dust cup is aligned with the grooves in the tool.
1
015352
To remove the dust cup, pull the chuck cover in the
direction as shown in the figure and with the chuck
cover pulled take the bit out of the tool.
1. Dust cup
Bit diameter
6 mm (1/4") - 14.5 mm (9/16")
12 mm (15/32") - 16 mm (5/8")
1. symbol
2
2. Grooves
3. Dust cup
symbol on the
1. Bit
2. Chuck cover
2
1
015353
And then grab the attachment at the foot of dust cup
and take it out.
1
011507
1
2
015256
1
012896
NOTE:
When installing or removing the dust cup, the cap
•
may come off the dust cup. At that time, proceed
as follows. Remove the bellows from the
attachment and fit the cap from the side shown in
the figure with its flat side facing upward so that
the groove in the cap fits in the inside periphery of
the attachment. Finally, mount the bellows that has
been removed.
9
1. Attachment at
the foot of dust
cup
1. Bellows
2. Attachment
2
1. Inside periphery
2. Flat side
3. Attachment
4. Cap
5. Groove
3
4
5
1. Cap
2. Attachment
2