STANDARD ACCESSORIES
1 Safety glasses ....................................... 1
OPTIONAL ACCESSORIES
Full Sequential Actuation Mechanism
kit (Sequential Trip Mechanism kit)
Pneumatic Tool Lubricant
.8 oz. (25 cc) oil feeder(Code No. 877153)
4 oz. (120 cc) oil feeder(Code No. 874042)
1 quart (1 ltr) can
NOTE: Accessories are subject to change
without any obligation on the part of
HITACHI.
APPLICATIONS
Floor and wall framing.
Truss build-up, Window build-up.
Subflooring and roof decking.
Wall sheathing.
Mobile home and modular housing
construction.
BEFORE OPERATION
Read section titled "SAFETY" (pages 5 – 8).
Make sure of the followings before operation.
WORKING ENVIRONMENT
No flammable gas, liquid or other
flammable objects at worksite.
Clear the area of children or
unauthorized personnel.
1
... sold separately
(Code No. 886283)
(Code No. 876212)
WARNING
AIR SUPPLY
Never connect Nailer to pressure
which potentially exceeds 200 psi (13.7
bars 14 kgf/cm
Never use non relieving coupler on
Nailer.
1. Power source
Use
only
compressed air as a power source for this
Nailer.
Air compressors used to supply
compressed air to this Nailer must
comply with the requirements of the
latest version of ANSI Standard B 19.3
"Safety Standard For Compressors For
Process Industries".
Moisture or oil in the air compressor may
accelerate wear and corrosion in the
Nailer.
Drain daily.
2. Filter-Regulator-Lubricator
Use a regulator with a pressure range of
0 – 120 psi
(0 – 8.3 bar
Filter-regulator-lubricator units supply an
optimum condition for the Nailer and
extend the Nailer life.
These units should always be used.
Filter .............. The
Regulator ...... The regulator controls the
— 11 —
English
DANGER
NEVER
oxygen or other
bottled gases.
Explosion may
occur.
WARNING
2
).
clean,
dry,
regulated
2
0 – 8.5 kgf/cm
).
filter
removes
moisture and dirt mixed in
compressed air.
Drain daily unless fitted
with an automatic drain.
Keep the filter clean by
regular maintenance.
operating pressure for
safe operation of the
Nailer.
use