Maintenance Maintenance And Inspection - Hitachi NR 90AF Instrucciones Y Manual De Seguridad

English
NOTE:
The information contained in this Manual is designed to assist you in the safe
maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that differ
from those on your own Nailer.
MAINTENANCE AND
INSPECTION
Read section titled "SAFETY" (pages 5 – 8).
Disconnect air hose and remove all
nails from Nailer when:
1) doing maintenance and inspection;
and
2) clearing a jam.
1. Inspecting the magazine
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove paper chips
or wooden chips which may have
accumulated in the magazine. Lubricate
it with Hitachi pneumatic tool lubricant.
CAUTION
Check that the nail feeder slides
smoothly by pulling it with finger.
If not smooth, nails can be driven at an
irregular angle and hurt someone.
MAINTENANCE
WARNING
1
Disconnect
Cloth
air hose
2. Storing
When not in use for an extended period,
apply a thin coat of the lubricant to the
steel parts to avoid rust.
Do not store the Nailer in a cold weather
environment.
Keep the Nailer in a warm area.
When not in use, the Nailer should be
stored in a warm and dry place.
Keep out of reach children.
3. WARNING LABEL
Change the WARNING LABEL if missing
or damaged.
A new WARNING LABEL is available from
a Hitachi authorized service center.
4. Maintenance chart (page 22)
5. Operator troubleshooting (pages 22 – 23)
6. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Remarks
CAUTION
Repair, modification and inspection of
Hitachi Power Tools must be carried out
by an Hitachi Authorized Service Center.
This Parts List will be helpful if presented
with the tool to the Hitachi Authorized
— 20 —
Warning
label