Levelling The Stove; System Connections - Palazzetti ECOFIRE GINGER Manual Del Usario

5.6 LEVELLING THE STOVE

The stove must be levelled by adjusting the feet
(where featured), then checked using a spirit level
(Fig. 5.10).

5.7 SYSTEM CONNECTIONS

5.7.1 Electrical connection
The stove is connected to the electrical system
simply using the plug supplied.
The electrical connection (plug) must be easily
accessible when the stove is installed.
If the power cord is damaged it must be replaced
to prevent any kind of risk.
5.7.1.1 Earth
residual current circuit-breaker in accordance with
legislation in force.
5.7.2 Connection to an external timer thermostat
The stove can be connected to an external timer
thermostat that switches the stove on or off
according to the set temperature.
For electrical connection, refer to the wiring
5.7.3
system, rear or top , by simply rotating the output
with a screw (5.13 r/s).
In the case of upward smoke outlet, remove the
top cap by loosening the three screws. Insert the
aesthetic ring provided.
Noah model:
To remove the cap in this model, it is necessary
to lift the right top by unscrewing the screws (Fig.
5.12) and taking out the cap after removing the
26
A
A