Parts List; Installation To Wood Stud Wall - PEERLESS Paramount PP730 Instalación Y Montaje

Before you begin, make sure all parts shown are included with your product.
Parts may appear slightly different than illustrated.

Parts List

Description
AA wall arm assembly
M4 x 12 mm phillips screw
A
B M4 x 20 mm phillips screw
retaining spacer
C
#14 x 2.5" wood screws
D
E 5 mm allen wrench
concrete anchors
F
G cable ties
3/16" allen wrench
I
B
A
C
D

Installation to Wood Stud Wall

WARNING
• Make sure that the supporting surface will safely support
the combined load of the equipment and all attached
hardware and components.
Using a stud finder, locate and mark the edges of the
1
wood stud used in mounting this product. Use of an
edge to edge stud finder is highly recommended. Use a
level to draw a vertical line down the center of the stud.
Use wall plate as template to mark center of holes
along the vertical line. Drill two 5/32" (4 mm) dia. holes
2.5" (65 mm) deep. Attach wall arm assembly (AA) to
wall using two #14 x 2.5" flat head wood screws (D) as
shown in figure 1.1.
Skip to step 2 on page 4.
WARNING
• Tighten screws so that wall plate is firmly attached, but
do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the
center of the studs. The use of an "edge to edge" stud
finder is highly recommended.
PP730 PP730-S
Qty. Part # Part #
1 095-0488-GB 095-0488-SS
4 504-9013 504-2013
4 504-9020 504-2014
4 590-5005 590-5003
2 520-1202 520-2165
1 560-9640 560-9640
2 590-0097 590-0097
2 560-1725 560-2007
1 560-0071 560-0071
E
F
G
AA
I
WOOD STUD
WALL
D
fig. 1.1
AA