Stihl MS 362 C-M Manual De Instrucciones página 39

1
4
Push the hand guard (1) forward –
N
the chain is locked.
The Master Control lever is in the normal
run position F.
If the engine is cold: Press down the
N
trigger lockout (2) and pull the
throttle trigger (3) at the same time.
Hold both levers in that position and
set the Master Control lever to start
symbol }.
Hold your saw firmly.
N
Pull the starter grip quickly and
N
firmly as often as necessary until the
engine starts.
If the engine does not start: Move
N
the Master Control lever to start
position } and repeat starting
procedure.
MS 362 C-M
As soon as the engine runs
If the engine was started in the start
N
position }: Press down trigger
2
lockout (2) and the pull the throttle
trigger (3) at the same time – the
3
Master Control lever (4) moves to
the run position F and the engine
settles down to idling speed.
Pull the hand guard back towards
N
the front handle.
The chain brake is now disengaged –
your saw is ready for operation.
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the clutch and chain
brake.
STOP
4
2
3
At very low outside temperatures
Change over to winter operation if
N
necessary – see "Winter Operation".
Stopping the engine
4
Move the Master Control lever in the
N
direction of STOP or † – when
released, the Master Control lever
springs back to the normal run
position F.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
or:
It is possible that the fuel-air mixture in
the combustion chamber is over-rich
and has flooded the engine.
Remove the spark plug – see
N
"Spark Plug".
Dry the spark plug.
N
English
STOP
37