Adjusting The Nailing Depth; Changing The Exhaust Direction - Hitachi NV 45AC Manual De Instrucciones

English

ADJUSTING THE NAILING DEPTH

To assure that each nail penetrates to the same depth, be
sure that:
1) the air pressure to the Nailer remains constant
(regulator is installed and working properly), and
2) the Nailer is always held firmly against the workpiece.
If nails are driven too deep or shallow into the workpiece,
adjust the nailing in the following order.
1 DISCONNECT AIR HOSE FROM NAILER
2 If nails are driven too deep, turn the adjuster to the
shallow side.
The ajuster moves 0.5 mm every times it is rotated
with a click.
Turn Adjuster
Too Deep
If nails are driven too shallow, turn the adjuster to the
deep side.
Turn Adjuster
Too Shallow
3 Stop turning the adjuster when a suitable position is
reached for a nailing test.
4 Connect the air hose.
ALWAYS WEAR EYE PROTECTOR.
Perform a nailing test.
5 DISCONNECT AIR HOSE FROM NAILER.
6 Choose a suitable position for the adjuster.
Adjuster
1 5
Disconnect
air hose
Flush
Flush
— 14 —
CHANGING THE EXHAUST
DIRECTION
The direction of the exhaust vent can be changed by
turning the head ring.
Exhaust Vent
Head Ring