Operation - Craftsman 247.378970 Manual Del Usuario

Drive Control
Recoil Starter
Blade Control
The blade control is attached to the upper handle of the mower. Depress and
squeeze it against the upper handle to operate the unit. Release it to stop engine
and blade.
This blade control is a safety device. Never attempt to bypass its operation.
Drive Control
The drive control is located on top of the upper handle and is used to engage the
drive. Squeeze it against the upper handle to engage the drive; release it to slow
down or stop mower from propelling.
Craftsman Lawn Mowers conform to the safety standard of the American National Standards Institute (ANSI).

OPERATION

Trail Shield
(Not Shown)
WARNING
Meets ANSI Safety Standards
Blade Control
Cutting Height
Adjustment
Lever
Figure 12
Cutting Height Adjustment Lever
One adjustment lever is located on the left rear wheel and one is located on the left
front wheel. Both levers have to be at the same position to ensure a uniform cut. To
adjust the cutting height, refer to the Assembly Section.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand behind the unit and
pull the recoil starter rope to start the unit.
Trail Shield
The trail shield is attached to the rear of the mower and is there to protect the
operator from flying debris. Do not use the mower unless the shield is fully
functional and in place.
12
Cutting Height
Adjustment
Lever