Operating Modes - Danby DPA100EAUWDB Manual Del Propietário

OPERATING INSTRUCTIONS

Operating Modes

• Cool Mode
Choose cool mode to set the cooling function. Use
the up and down Arrows to choose the desired
temperature. Press the fan button to adjust the fan
speed.
The temperature can be set within a range of 18 -
32°C (64 - 90°F).
The exhaust hose should be installed during cool
mode to ensure the best results.
• Dry Mode
Choose dry mode to remove excess moisture from
the air during periods of high humidity. All water
pulled from the air will collect inside the appliance
and evaporate due to the heat from the compressor.
In especially humid conditions, it may be necessary
to empty the drain pan when it becomes full. Press
the fan button to adjust the fan speed.
The exhaust hose should be installed during dry
mode to ensure the best results.
• Fan Mode
Choose fan mode to run the internal fan without
engaging the cooling function. Press the fan button
repeatedly to choose the fan speed, low, med, high.
Timer Function
To set the turn off timer:
• Ensure the appliance is turned on.
• Press the timer button, the time on the display
will fl ash.
• Press the timer button to select the desired
amount of hours before the unit turns off.
To set the turn on timer:
• Ensure the appliance is turned off.
• Press the timer button, the time on the display
will fl ash.
• Press the timer button to select the desired
amount of hours before the unit turns on.
Notes:
• The display will revert back to showing the
temperature setting if the appliance does not
receive a signal within a 5 second period during
programming.
• Turning the appliance on or off at any time
or adjusting the timer setting to 0.0 hours will
cancel the timer settings.
• The timer can be set between 1 - 24 hours.
Sleep Function
The Sleep Function can be used to conserve energy
during sleeping hours.
When selected, the set temperature will increase
by 2 degrees over a 2 hours period. The appliance
will hold the new set temperature for 7 hours before
automatically returning to normal operation.
The Sleep Function can be canceled at any time by
pressing the Sleep Button.
8