Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi DH 18DL Manual De Instrucciones

Taladro de percusion sin cable
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

APPLICATIONS

Rotation and striking function
Drilling anchor holes
Drilling holes in concrete
Drilling holes in tile
Rotation only function
Drilling in steel or wood
Tightening machine screws, wood screws
REMOVAL AND INSTALLATION METHOD
OF BATTERY
How to install the battery.
Align the battery with the groove in tool handle
and slip it into place.
Always insert it all the way until it locks in place
with a little click, If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you (Fig. 3).
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch (2 pcs) of the battery (Fig. 3).
Battery
Push

CHARGING METHOD

NOTE:
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.

ASSEMBLY AND OPERATION

Handle
Insert
Pull out
Latch
Fig. 3
1.
Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been inserted
into the receptacle, the charge status lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if
damaged.
immediately.
2.
Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 4. Make sure it contacts the bottom of the
battery charger.
Charge status
lamp (red)
Overheat lamp (green)
3.
Charging
When the battery is connected to the battery
charger, charging will commence and the charge
status lamp will light in red. (See Table 2)
NOTE:
If the charge status lamp flickers in red, pull out
the plug from the receptacle and check if the
battery is properly mounted.
When the battery is fully charged, the charge status
lamp will blink in red slowly. (At 1-second intervals)
(See Table 2)
English
Have
it
repaired
Battery
Fig. 4
11

Publicidad

Tabla de contenido
loading

Tabla de contenido