Hitachi DH 40FB Instrucciones De Manejo página 7

SPECIFICATIONS
Voltage (by areas)*
Power input
Capacity
No load speed
Full-load blow
Weight (without cord, side handle)
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Case (Molded plastic) ............................................... 1
(2) Side Handle ................................................................ 1
(3) Stopper ........................................................................ 1
(4) Hexagon Bar Wrench (for 6 mm screw) ............. 1
(5) Hexagon Bar Wrench (for 5 mm screw) ............. 1
(6) Hammer Grease A .................................................... 1
(7) Dust Cover ................................................................. 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Through-hole drilling (Rotation + Hammering)
(1) Drill bit (Spline shank)
Overall length: 400 mm
External dia.: 12.7, 25.4, 38.1 mm
2. Anchor hole drilling (Rotation + Hammering)
(3) Cotter
(1) Drill bit (taper shank)
Taper shank
Application drill bit
adapter
Taper shank adapter formed A-
A-taper
taper or B-taper is provided as
optional accessory, but drill bit for
B-taper
it is not provided.
3. Large dia. hole boring (Rotation + Hammering)
(Guide (1) Center
plate) pin
(2) Taper shank
adapter
(Spline shank)
(2) Core (3) Core bit
bit shank
(Spline shank)
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
950 W*
Drill bit: 40 mm
Core bit: 105 mm
180 – 360/min.
1400 – 2800/min.
6.8 kg
(1) Center pin
Applied to core bits from 38 mm to 105 mm
(2) Core bit
External dia. 50, 105 mm (with guide plate)
(3) Core bit shank
Applied to core bits above 38 mm
4. Crushing (Hammering)
(1) Bull point
Overall length: 300 mm
5. Groove digging and edging (Hammering)
(1) Cold chisel
Overall length: 300, 460 mm
6. Asphalt cutting (Hammering)
7. Syringe (for chip removal)
8. Hammer grease A
500 g (in a can)
70 g (in a green tube)
30 g (in a green tube)
Optional accessories are subject to change without
notice.
APPLICATIONS
Drilling holes in concrete
Drilling anchor holes
Crushing concrete, chipping, digging, and squaring
(by applying optional accessories)
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
English
(1) Cutter
6