Oster TSSTTVDFL1 Manual De Instrucciones página 16

u W
sing the arm
Step 1. Turn the Function Knob to the Warm function.
When you select the Warm function, the lower
heating element will heat.
Default Temperature: 150ºF.
Default Time: 60 minutes.
You may manually activate the Turbo
Convection Heat by pressing the Turbo
button once to turn it on. The blue light of
the Turbo button will turn on.
Step 2. To set the temperature:
Turn the Temperature Knob if you wish to
increase or decrease the temperature setting.
For the Warm Function, the temperature
can be set from 150 to 200ºF in 25-degree
increments.
Step 3. To set the time:
Turn the Time Knob if you wish to
increase or decrease the warming time.
The maximum time setting for Warm is 60
minutes (1 hour). Once you have selected
the desired warming time, press the Start
button to initiate the warming process.
Step 4. To Start:
Press the Start/Cancel Button to start the
warming process. The red Start/Cancel
Button light will illuminate. The LCD
Display will show the Warm Function,
the countdown time and the selected
temperature. The unit will begin to work
and the timer will start counting down.
When the Warming cycle is complete, the
unit will emit 3 beeps. The LCD and the
Start/Cancel Button Light will turn off after
30 seconds.
NOTE: You can cancel the warming cycle at any time
by pressing the Start/Cancel Button once. The
red Start/Cancel Button light will turn off
whenever a function has been completed or a
function is manually cancelled.
F (s
unction ee
English-16
F . 9)
ig
Figure 9