Faults
If the paper jams in the appliance
This means that you have attempted to feed too much paper into the appliance
(max. 10 sheets 80 g/m
1) Move the switch
The appliance now goes into reverse and the paper that is being shredded
is ejected.
2) Pull the paper out of the appliance and then set the switch
The appliance is now ready for use again.
If the appliance suddenly stops working
This means that the appliance has overheated and the automatic safety cut-out
has activated itself.
WARNING! RISK OF INJURY!
►
Remove the power plug from the wall socket to avoid unintended starting of
the appliance.
1) Place the switch
2) Allow the appliance to cool down.
3) Put the mains plug back into the socket.
4) Switch the appliance on, by moving the switch
If the appliance cannot be switched on
■
Place the switch
■
Try a different wall socket.
■
The appliance is possibly defective. Have the appliance checked by a qualified
technician.
■
The appliance has overheated and triggered the automatic safety cut-out.
Proceed as follows:
WARNING! RISK OF INJURY!
►
Remove the power plug from the wall socket to avoid unintended starting of
the appliance.
1) Place the switch
2) Allow the appliance to cool down.
3) Put the mains plug back into the socket.
4) Switch the appliance on, by moving the switch
UAV 250 A1
paper).
2
into the "REV" position if the paper causes a blockage.
in the "OFF" position.
in the "OFF" position.
in the "OFF" position.
to "AUTO".
into the "AUTO" position.
into the "AUTO" position.
GB │ IE
21
│
■