Install The Lights; Attach The Emergency Release Rope And Handle - Craftsman SMART CONTROL Manual Del Propietário

INSTALLATION STEP 6

Install the Lights

1. Press the release tabs on both sides of lens. Gently rotate
lens back and downward until the lens hinge is in the fully
open position. Do not remove the lens.
2. Insert an A19 incandescent (100 watt maximum) or
compact fluorescent (26W, 100W equivalent) light bulb
into the light socket. The lights will turn ON and remain lit
for approximately 4-1/2 minutes when power is connected.
Then the lights will turn OFF.
3. Reverse the procedure to close the lens.
4. If the bulbs burn out prematurely due to vibration, replace
with a garage door opener bulb. Use A19, standard neck
garage door opener for replacement.
NOTE: Do not use halogen, short neck, or specialty light bulbs
as these may overheat the end panel or light socket. Do not
use LED bulbs as they may reduce the range or performance of
your remote control(s).
INSTALLATION STEP 7

Attach the Emergency Release Rope and Handle

1. Insert one end of the emergency release rope through the
handle. Make sure that "NOTICE" is right side up. Secure with
an overhand knot at least 1" (2.5 cm) from the end of the rope
to prevent slipping.
2. Insert the other end of the emergency release rope through
the hole in the trolley release arm. Mount the emergency
release within reach, but at least 6 feet (1.83 m) above floor,
avoiding contact with vehicles to prevent accidental release
and secure with a knot.
NOTE: If it is necessary to cut the emergency release rope, seal
the cut end with a match or lighter to prevent unraveling. Ensure
the emergency release rope and handle are above the top of all
vehicles to avoid entanglement.
To prevent possible OVERHEATING of the end panel or light
socket:
Use ONLY A19 incandescent (100W maximum) or compact
l
fluorescent (26W maximum) light bulbs.
DO NOT use incandescent bulbs larger than 100W.
l
DO NOT use compact fluorescent light bulbs larger than 26W
l
(100W equivalent).
DO NOT use halogen bulbs.
l
DO NOT use short neck or specialty light bulbs.
l
Release Tab
100 Watt (Max)
Standard Light Bulb
or
To prevent possible SERIOUS INJURY or DEATH from a falling
garage door:
If possible, use emergency release handle to disengage
l
trolley ONLY when garage door is CLOSED. Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.
NEVER use emergency release handle unless garage doorway
l
is clear of persons and obstructions.
NEVER use handle to pull door open or closed. If rope knot
l
becomes untied, you could fall.
Trolley
Trolley
Release Arm
Emergency
Release Handle
19
Compact Fluorescent
Light Bulb
100 Watt (Max)
Standard Light Bulb
Lens
Hinge
Compact Fluorescent
Light Bulb
Overhand
Knot
or