Program The Travel - Craftsman SMART CONTROL Manual Del Propietário

ADJUSTMENT STEP 1

Program the Travel

1. Press and hold the
Adjustment Button until the
UP Button begins to flash
and/or a beep is heard.
2. Press and hold the UP
Button until the door is in
the desired UP position.
NOTE: The UP and DOWN
Buttons can be used to
move the door up and
down as needed.
3. Once the door is in the
desired UP position press
and release the Adjustment
Button. The garage door
opener lights will flash
twice and the DOWN Button
will begin to flash.
IMPORTANT NOTE: For
one-piece door installations
refer to page 30.
4. Press and hold the DOWN
Button until the door is in
the desired DOWN position.
NOTE: The UP and DOWN
Buttons can be used to
move the door up and
down as needed.
5. Once the door is in the
desired DOWN position
press and release the
Adjustment Button. The
garage door opener lights
will flash twice and the UP
Button will begin to flash.
Without a properly installed safety reversal system, persons
(particularly small children) could be SERIOUSLY INJURED or
KILLED by a closing garage door.
Incorrect adjustment of garage door travel limits will
l
interfere with proper operation of safety reversal system.
After ANY adjustments are made, the safety reversal system
l
MUST be tested. Door MUST reverse on contact with 1-1/2"
(3.8 cm) high object (or 2x4 laid flat) on floor.
6. Press and release the UP
Button. When the door
travels to the programmed
UP position, the DOWN
Button will begin to flash.
7. Press and release the
DOWN Button. The door will
travel to the programmed
DOWN position.
Programming is complete.
* If the garage door opener lights are flashing 5 times during the
steps for Program the Travel, the programming has timed out. If
the garage door opener lights are flashing 10 times during the
steps for Program the Travel, the safety reversing sensors are
misaligned or obstructed (refer to page 29). When the sensors
are aligned and unobstructed, cycle the door through a
complete up and down cycle using the remote control or the UP
and DOWN buttons. Programming is complete. If you are unable
to operate the door up and down, repeat the steps for
Programming the Travel.
31