Battery Backup; Install The Battery; Test The Battery; Charge The Battery - Craftsman SMART CONTROL Manual Del Propietário

BATTERY BACKUP

Install the Battery

1. Unplug the garage door opener.
2. Open the light lens on the right side panel of the garage door
opener. Use a Phillips head screwdriver to remove the battery
cover on the garage door opener.
3. Partially insert the battery into the battery compartment with
the terminals facing out.
4. Connect red (+) and black (-) wires from the garage door
opener to the corresponding terminals on the battery.
5. Replace the battery cover.
6. Plug in the garage door opener.
7. Wait for the green Battery Status LED to start flashing before
proceeding to test the battery.
Status LED

Test the Battery

1. Unplug the garage door opener. The battery status LED will
either glow solid orange indicating opener is operating on
battery power or will flash indicating low battery power. NOTE:
Make sure the garage door opener is unplugged.
2. Open and close the door using the remote control or door
control. The garage door opener may run slower if the battery
is not fully charged. The battery will take 24 hours to fully
charge.
3. Plug in the garage door opener. Verify the battery status LED
is flashing green, indicating the battery is charging.

Charge the Battery

The battery charges when the garage door opener is plugged into
a 110Vac electrical outlet that has power and requires 24 hours to
fully charge. A fully charged battery supplies 12Vdc to the garage
door opener for one to two days of normal operation during an
electrical power outage. After the electrical power has been
restored, the battery will recharge within 24 hours. The battery will
last approximately 1 to 2 years with normal usage. Instructions for
replacement are provided with the battery. To obtain maximum
battery life and prevent damage, disconnect the battery when the
garage door opener is unplugged for an extended period of time,
such as a summer or winter home.
NOTE: When the garage door opener is in battery backup mode
the garage door opener lights, Timer-to-Close, and Remote Close
features are unavailable.
To reduce the risk of FIRE or INJURY to persons:
l
l
l
ALWAYS wear protective gloves and eye protection when
changing the battery or working around the battery
compartment.
Battery
Battery Cover
Battery Status LED
NOTE: The Battery Status LED is most visible with the garage door
opener light off. Battery does not have to be fully charged to
operate the garage door opener.
GREEN LED:
All systems are normal.
A solid green LED light indicates the battery is fully charged.
l
A flashing green LED indicates the battery is being charged.
l
ORANGE LED:
The garage door opener has lost power and is in battery backup
mode.
A solid orange LED with beep, sounding approximately every 2
l
seconds, indicates the garage door opener is operating on
battery power.
A flashing orange LED with beep, sounding every 30 seconds,
l
indicates the battery is low.
RED LED:
The garage door opener's 12V battery needs to be replaced.
A solid red LED with beep, sounding every 30 seconds,
l
indicates the 12V battery will no longer hold a charge and
needs to be replaced. Please call for replacement battery to
allow your system to operate during a power outage.
33
Disconnect ALL electric and battery power BEFORE
performing ANY service or maintenance.
Use ONLY Craftsman part #41B822 for replacement battery.
DO NOT dispose of battery in fire. Battery may explode. Check
with local codes for disposal instructions.