Publicidad
Idiomas disponibles
Idiomas disponibles
Additional safety information
▪ The appliance should be connected only to earthed wall sockets that have been installed in
accordance with the regulations. The power cable and plug must be dry.
▪ Do not pull or clamp the connection cable over sharp edges. Do not leave it dangling. Protect it
from heat and oil.
▪ Do not place the appliance on hot surfaces, such as on hotplates or similar areas, and do not
operate near naked flames.
▪ Never pull the mains plug out of the socket by the cable or with wet hands.
▪ Stop using the appliance and/or pull the mains plug out of the socket immediately if:
⋅
The appliance or power cord is damaged
⋅
you suspect that the device may be defective following a fall or similar incident.
⋅
if malfunctions occur during use
⋅
before cleaning
⋅
after every use.
In such cases, arrange for the appliance to be repaired.
▪ Do not immerse the appliance in water.
▪ We accept no liability for any damage caused as a result of misuse, incorrect operation or improper
repairs. Warranty payments are also excluded in such cases.
▪ The appliance is not intended for commercial use.
▪ Do not cover the appliance.
▪ Pull the mains plug out of the socket after use and open the appliance.
▪ Leave the appliance to cool down before transporting it or putting it away.
▪ Never clean the appliance and the cable in the dishwasher!
▪ The connection cable must not come into contact with hot appliance parts!
▪ Place the appliance on a flat, solid surface.
▪ Do not disassemble or open the appliance housing - there is a risk of electrocution!
▪ Only operate the appliance with original accessories from WMF.
▪ Never leave the appliance unattended when the mains plug is connected! While the appliance is
in use and cooling down, make sure that other persons cannot accidentally touch it as this could
cause burns!
▪ Make sure the appliance is positioned on a secure, horizontal surface with plenty of clearance to
the wall and other objects.
▪ Remove all packaging material / films / transport locks if applicable
▪ Clean the parts with a soft cloth before first use
▪ With the windows open, heat the grill plates for the first time for around 2-3 minutes each in
order to remove any manufacturing residues. This could cause a slight smell, which is completely
harmless.
non-stick coating
Never touch the scratch-sensitive non-stick coating with sharp or pointed objects. Use a barbecue fork
and tongs made of wood or synthetic material. When using your
new appliance for the first time there may be a little smoke or odour. This is for technical reasons and
is perfectly normal.
Warning: After use, switch the appliance off using the on / off switch and pull the mains plug out of
the socket.
10
Initial operation
▪ Clean all the plates with a damp cloth and some washing-up liquid before using the appliance for the
first time. The plate set found in the appliance can be removed using the square push-buttons.
▪ Select the plate set you want, dry it carefully and place it in the appliance.
▪ Insert the plate guides on the respective plate halves in the designated appliance slots at an angle of
approx. 30°.
Note: Please note that the waffle plate with the wide guides may only be inserted in the top half of
the appliance. The sandwich plates can be inserted in either the top or the bottom half.
After inserting the plates, press them downwards until you hear them lock into place.
Note: Both plate halves must be inserted, otherwise the appliance does not work properly.
▪ Brush the plates with a few drops of oil.
▪ Connect the mains plug to an earthed wall socket.
▪ Switch the appliance on at the on/off switch to heat it up. The indicator light glows red.
▪ The indicator light changes colour from red to white as soon as the optimum temperature is reached.
Note: There may be a slight odour the first time you use your new appliance. This is for technical
reasons and is perfectly normal.
▪ Push the button on the inside of the handle up to open the appliance.
▪ Load the plate and close the appliance. Depending on the amount of filling, the lid clicks into place
one or two times.
Note: Do not eat the first waffle cooked in the new appliance.
▪ After a short time, the red indicator light comes on again to show that the appliance is heating up.
▪ Open the appliance and remove the snacks as soon as they reach the desired browning level.
Tips for successful sandwiches
▪ It is advisable to have all the ingredients ready before you begin toasting. You can also prepare a
certain number of sandwiches in advance in order to reduce the waiting time.
▪ All types of bread can be used as long as they fit on the plates.
▪ The toasting time depends on the moisture content of the bread and the type of filling used.
▪ Check that the sandwiches are toasting according to your taste.
▪ Remove the sandwiches using a wooden spatula to protect the coating.
Sandwich recipe idea:
ciabatta sandwich
Ingredients:
1 Ccabatta
2 tbsp. butter
250 g rocket
2 small tomatoes
2 tbsp. olive oil
2 balls of mozzarella
4 rocket pesto
100 g Serrano ham
salt, pepper
Preparation:
Cut the ciabatta in half lengthways, spread butter on one half. Wash
the rocket, remove the hard stems, shake dry and then spread evenly on the halved ciabatta with the
Serrano ham. Wash and dry the tomatoes, remove the stem and slice. Drain and slice the mozzarella.
Place the tomato and mozzarella on the sandwich and spread a little pesto on the mozzarella
slices. Place on the top half of the ciabatta, press down and toast the sandwich in the Lono Snack Master.
11
Publicidad
