Installation Instructions - HAMPTON BAY 473-463 Manual De Instrucciones

PARTS INCLUDED FOR INSTALLATION (parts are not to
scale):
1 ea Mounting
Bracket (#7)
2 ea Hex
Nuts (#9)

INSTALLATION INSTRUCTIONS:

1. Thread the Hex Nut (#9) onto the Nipple (#6). Thread the Nipple (#6) into the center hole of the Mounting
Bracket (#7). Do not tighten the Hex Nut (#9) at this time. (Fig. 2)
2. Pull the power supply wires out from the Outlet Box (#4), and mount the Mounting Bracket (#7) to the Outlet Box
(#4), using the Bracket Mounting Screws (#8). (Fig. 2)
3. Attach the Black Supply Wire (#5) to the Black Fixture Wire (#12) and the White Supply Wire (#16) to the White
Fixture Wire (#13) using Wire Nuts (#14). Connect the Fixture Ground Wire (#11) and the Supply Ground Wire
(#15) together using a Wire Nut (#14). (Fig. 2) Wrap all wire connections with electrical tape for a more secure
connection. Note: If you have electrical questions, consult your local electrical code for approved grounding
methods.
4. Carefully tuck all Wires and Wire Nuts (#14) into the Outlet Box (#4). Place the Fixture Pan (#1) over the Outlet
Box (#4), flush against the wall surface, making sure the Nipple (#6) feeds through the hole of the Fixture Pan
(#1). Adjust the Nipple (#6) so that it protrudes about ¼ inch from the surface of the Fixture Pan (#1). Remover
the Fixture Pan (#1) from the wall and tighten the Hex Nut (#9) against the Mounting Bracket (#7). Replace the
Fixture Pan (#1) over the Outlet Box (#4) and thread the Lock Nut (#3) onto the Nipple (#6) to secure the Fixture
Pan (#1) against the wall. (Fig. 2)
5. Proceed back to the Assembly Instructions.
6. After installing the fixture, caulk the upper 2/3s of the Cage (#17) to mounting surface. Leave the bottom 1/3 un-
caulked for drainage of any water that might leak into the enclosure. The manufacturer recommends a non-drying
exterior caulking material. A good example is a clear silicone rubber sealant for exterior use.
7. Installation is complete. Turn on power at the circuit breaker or fuse box. Turn the light switch on to activate the
fixture.
2 ea Bracket Mounting
Screws (#8)
1 ea Nipple (#6)
2 ea Lock
Nuts (#3)
3 ea Wire
Nuts (#14)
Page 7