Installation Instructions - HAMPTON BAY SKU 497-083 Manual De Instrucciones

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1ea Ground Screw (#9)
1ea Cross Bar (#6)

INSTALLATION INSTRUCTIONS:

1. Screw the two Mounting Screws (#8) into the Cross Bar (#6). Mount the Cross Bar (#6)
to the Outlet Box (#4) using the two provided Outlet Box Screws (#7). [Make sure the
threads of the Mounting Screws (#8) are facing outside when the Cross Bar (#6) is
attached to the Outlet Box (#4).]
2. Wrap the ground wire from the fixture around the Ground Screw (#9) on the Cross Bar
(#6), and then connect the ground wire from the fixture to the ground wire from the
Outlet Box (#4). Connect the white wire from the fixture to the white wire (neutral wire)
from the Outlet Box (#4). Connect the black wire from the fixture to the black wire (live
wire) from the Outlet Box (#4). Cover the connections using the provided Wire
Connectors (#5). Wrap the wire connections with electrical tape for a more secure
connection. Position the wires back inside the Outlet Box (#4). Note: If you have
electrical questions, consult your local electrical code for approved grounding methods.
3. Place the fixture body to the wall by aligning the protruding Mounting Screws (#8) all the
way through the Wall Plate (#1). Tighten the fixture to the wall by screwing the two Lock
Nuts (#2) onto the two protruding Mounting Screws (#8).
4. Once the fixture is mounted on the wall, caulk the space between the wall and the upper
3/4 area of the Wall Plate (#1) to prevent water seeping into the Outlet Box (#4). Leave
the bottom 1/4 area uncaulked for drainage of any water which might leak into the
enclosure.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.
Page 6
2ea Outlet Box Screws (#7)
2ea Lock Nuts (#2)
2ea Mounting Screws (#8)
3ea Wire Connectors (#5)