Installation Instructions - HAMPTON BAY 6940500313283 Manual De Instrucciones

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1ea Lock Nut (#4)
1ea Ground Screw (#14)

INSTALLATION INSTRUCTIONS:

1. Screw the Nipple (#16) a half-inch into the Mounting Strap (#13). Tighten the Hex Nut
(#15) against the Mounting Strap (#13) to secure the Nipple (#16). Attach the Mounting
Strap (#13) to the Outlet Box (#11) using the two Outlet Box Screws (#17). [Make sure
the longer end of the Nipple (#16) is facing outside when the Mounting Strap (#13) is
attached to the Outlet Box (#11).]
2. Wrap the ground wire from the fixture around the Ground Screw (#14) on the Mounting
Strap (#13), and then connect the ground wire from the fixture to the ground wire from the
Outlet Box (#11). Connect the white wire from the fixture to the white wire (neutral wire)
from the Outlet Box (#11). Connect the black wire from the fixture to the black wire (live
wire) from the Outlet Box (#11). Cover the three wire connections using the three Wire
Connectors (#12). Wrap the three wire connections with electrical tape for a more secure
connection. Position the wires back inside the Outlet Box (#11). Note: If you have
electrical questions, consult your local electrical code for approved grounding methods.
3. Place the Canopy (#1) over the Nipple (#16) all the way to the ceiling. Screw the Lock
Nut (#4) onto the Nipple (#16) until the Canopy (#1) is held firmly against the ceiling.
4. Once the fixture is mounted on the ceiling, caulk the space between the ceiling and the
whole area of the Canopy (#1) to prevent water seeping into the Outlet Box (#11).
5. Before completing Installation, please return to Assembly Instruction #4.
6. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.
Page 6
3ea Wire Connectors (#12)
1ea Hex Nut (#15)
1ea Mounting Strap (#13)
1ea Nipple (#16) 2ea Outlet Box Screws (#17)