Installation Instructions - HAMPTON BAY Home Depot 895-964 Manual De Instrucciones

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1 Ground Screw (#6)
1 Circular Strap (#8)

INSTALLATION INSTRUCTIONS:

1. Attach the Circular Strap (#8) to the Outlet box (#11) with the two Outlet box screws
(#7) as shown. The side of the Circular Strap marked "GND" must face out.
2. Thread the Mounting Screws (#9) into the pre-drilled holes in the Circular Strap (#8)
spaced the same distance apart as the holes in the Backplate (#1).
3. Connect the white wire from the fixture to the white wire from the Outlet Box (#11),
and the black wire from the fixture to the black wire from the Outlet Box (#11).
Cover the two wire connections using the two provided Wire Connectors (#10).
Wrap the two wire connections with electrical tape for a more secure connection.
your outlet box has a ground wire (green or bare copper), connect fixture's ground
wire to it using the wire connector (#10). Otherwise connect the copper ground from
the fixture to Ground screw (#6) on the Circular Strap (#8).
electrical questions, consult your local electrical code for approved grounding
methods.
4. Mount the body of the fixture on the wall by aligning the protruding Mounting
Screws (#9) all the way through the holes on the BackPlate (#1). Be careful not to
pinch any of the wires between the fixture and the Outlet Box (#11). Tighten the
fixture to the wall by screwing the two Knurled Knobs (#2) onto the two protruding
Mounting Screws (#9).
5. To prevent moisture from entering the outlet box and causing a short, use clear
caulking (i.e. Indoor/Outdoor Silicone Sealant) to outline the outside off fixture
back-plate where it meets the wall leaving a space at bottom to allow moisture a
means to escape.
6. Install the proper light bulbs (not include) for your fixture. (DO NOT EXCEED THE
SPECIFIED WATTAGE!)
7. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn
the light switch on to activate the fixture.
3 Wire Connectors (#10)
2 Mounting Screw (#9)
2 Outlet Box Screws (#7)
2 Knurled Knob (#2)
Note: If you have
If
Page 6