SEVERIN WK 3479 Instrucciones De Uso página 22

beep signals is heard.
∙ Temperatures below 40 °C cannot be
selected.
Heating water
∙ Remove the water container from its
base; then turn the lid insert anti-
clockwise (UNLOCK) and take it off.
∙ Fill the container with water to the desired
level, observing the Min (0.5 l) and Max
(1.7 l for heating water) markings.
∙ Replace the lid insert and turn clockwise
(LOCK) until it is heard locking into place.
∙ Place the container back on its base.
∙ Insert the plug into a suitable wall socket.
A beep signal is heard and the display
shows C, followed by the current water
temperature inside the container.
∙ Press the 'Program' button twice. The
display shows 80. Use the +/– buttons
to set the desired temperature, and then
confi rm by pressing the ON/OFF button,
which lights up red.
∙ The kettle heats the water to the selected
temperature.
∙ Once the pre-set temperature has been
reached, the heating element switches
off, three beep signals are heard and
the current temperature is shown on the
display.
∙ The appliance goes into keep-warm
mode. The 'Program' button lights up
blue.
∙ The boiling process may be interrupted
by pressing the ON/OFF button.
∙ To pour hot water, remove the container
from its base.
∙ To prevent hot steam from being emitted,
ensure that the lid remains closed while
22
pouring out the water.
∙ Remove the plug from the wall outlet
after use.
∙ Do not leave any residual water in the
container.
Quick-Boil & Tea function
When the water container is placed
on the base and the ON/OFF button is
pressed, the water is heated to 100 °C
without the need to set a temperature –
the appliance is now in herbal-tea mode.
Pressing the ON/OFF button twice
returns the appliance to stand-by mode.
Making tea – general remarks
Preparing the appliance
∙ Remove the water container from its
base, turn the lid insert anti-clockwise
(UNLOCK) and take it off. Take out the
tea fi lter.
∙ Fill the container with water to the desired
level, observing the Min (0.5 l) and Max
(1.5 l for making tea) markings. Replace
the lid insert.
∙ Put the required amount of tea into the
tea fi lter.
∙ Select a programme or use the manual
mode to heat the water.
Fitting the tea fi lter
∙ Once the water is heated and three beep
signals are heard, release the lid insert
by turning it anti-clockwise, and remove
it. Caution: Take special care, as hot
steam may be emitted! If necessary,
use oven gloves.
∙ Fit the tea fi lter in the container,
observing the recess in the container lid;