Delta 31-735 Manual De Instrucciones página 10

ATTACHING THE SANDING UNIT TO THE CABINET
The belt/disc sander is heavy. Use two or more people to lift the unit to the top of the cabinet.
Disconnect the machine from the power source!
1. Place the sanding unit on top of the cabinet.
NOTE: Insert the sander drive belt through the hole (A)
FIG. 11.
2. Place a 5/16" lock washer on a 5/16-18 x 1/2" hex
head screw. From inside the cabinet, insert the screw
through one of the holes (B) Fig. 11, and into the
threaded hole in the sanding unit. Tighten the screw
securely.
3. Repeat this process for the three remaining holes (B)
Fig. 11.
4. Place a #10 washer on a #10-32 x 3/4" button-head
screw. From the inside of the cabinet, insert the screw
through one of the holes (C) Fig. 11 in the dust baffle
and cabinet and into the threaded hole in the sanding
unit. Tighten the screw securely.
5. Repeat for the three remaining holes.
INSTALLING THE DUST COLLECTOR INTAKE HOSE
Disconnect the machine from the power source!
1. Place a hose clamp (A) Fig. 12 on each end of hose
(B).
2. Slide one end of hose (B) Fig. 13 over the hose port
(C) on the dust baffle inside the cabinet. Secure it
with the hose clamp.
3. Slide the other end of the hose over the fan intake
port (F) Fig. 14 inside the cabinet. Secure it with the
hose clamp.
B
A
C
F
Fig. 13
10
C
B
A
B
Fig. 11
B
A
Fig. 12
Fig. 14