Delta 31-735 Manual De Instrucciones página 22

Máquina para acabados abrasivos con banda de 152 mm (6") y disco de 305 mm (12")
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

END SANDING WITH THE DISC
When sanding the ends of narrow workpieces, use the
sanding disc as shown in Fig. 62.
Sand on the left (downward) side of the
sanding disc (Fig. 62). Sanding on the right (upward)
side of the sanding disc could cause the workpiece
to be thrown upward and could cause personal
injury.
You must position the edge of the table a maximum of 1/16" away from the sanding belt to avoid
trapping the workpiece or your fingers between the table and the sanding belt.
CIRCLE SANDING WITH DISC
A circle sanding attachment is supplied with the sander. It enables you to sand circles up to 24" in diameter. To use:
Disconnect the machine from the power source!
1. Insert the stop block (A) Fig. 63 into the slot in the sanding disc table. Align the end of the outside edge (B) of the
block with the diameter of the circle shown on the scale. Tighten the screw in the stop block with a 5/32" hex
wrench (C) to hold the block in place.
2. Insert the guide pin (D) Fig. 64 in the center of the over-sized rough cut circle (E).
3. Insert the guide pin (D) Fig. 64 into the slot (F) of the disc sander table. Rotate the workpiece (E) Fig. 65.
continuously while sanding. When the guide pin contacts the stop pin, the workpiece will be a circle of the correct
size.
4. When necessary, adjust the scale (F) Fig. 66 by loosening the two screws (G), adjusting the scale in or out, and
tightening the two screws.
A
E
B
C
Fig. 63
Fig. 65
D
Fig. 64
F
Fig. 66
22
Fig. 62
E
F
G
G

Publicidad

Tabla de contenido
loading

Tabla de contenido