Air Conditioner Use; Starting Your Air Conditioner - Haier HWR05XCJ Manual De Uso Y Cuidado

Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least 3 minutes before
■
turning it back on. This keeps the air conditioner from blowing a
fuse or tripping a circuit breaker.
1. Remove the clear plastic film from the control panel.
2. Press POWER to turn on the air conditioner. The Power
indicator light will turn on.
NOTE: When the air conditioner is plugged in, the LED display
will show "88" for 3 seconds. After the air conditioner is turned
on for the first time, the display will show the current room
temperature and the fan is set to Low speed. When the air
conditioner is turned on at all other times, the display will show
the previous settings for 5 seconds, and then show the current
room temperature.
3. Select mode. See "Mode."
4. Select fan speed. See "Fan Speed."
5. Set temperature. See "Temperature."

AIR CONDITIONER USE

Do not try to operate your air conditioner in the Cool mode when
■
outside temperature is below 61°F (16°C). The inside evaporator
coil will freeze up, and the air conditioner will not operate
properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.

Starting Your Air Conditioner

Mode
1. Press MODE until you see the indicator light glow for the
2. Choose Fan, Cool.
NOTE: After 5 seconds, display will show the current room
temperature.
Fan Speed
1. Press FAN SPEED until you see the indicator light glow for
2. Choose High or Low.
NOTE: After 5 seconds, the display will show the current room
temperature.
desired setting.
Fan—Only the fan runs. Press SPEED to select High
■
or Low fan speed. The display shows the current room
temperature.
Cool—Cools the room. Press SPEED to select High or Low
■
fan speed. Press the TEMP/TIME up or down arrow button
to adjust the temperature.
the desired setting.
High—for maximum cooling
■
Low—for minimum cooling
■
9