PROBLEM
5. The machine emits
smoke during operation.
6. Battery power
reserve is low.
7. The battery charger is
not charging the battery.
If problems persist after implementing the solution, contact your Dealer.
14. ACCESSORIES ON REQUEST
14.1
BATTERIES
Different capacity batteries are available to
suit specific operating requirements. The list
of approved batteries for this machine can
be found in the "Technical Data" table.
14.2 BATTERY CHARGER
Device used to recharge the
(Fig. 15.A), standard (Fig. 15.B), dual (Fig. 15.C).
PROBABLE CAUSE
Damaged blower.
Severe working conditions
requiring greater
current absorption.
Battery is insufficient for
operating requirements.
Decrease in battery capacity.
Battery is not correctly inserted
in the battery charger.
Unsuitable environmental conditions.
Dirty contacts.
The battery charger is not energised.
Faulty battery charger.
battery: fast
Do not use the machine. Stop the
machine immediately,
from the battery backpack and
an Authorised Service Centre.
Optimise operations (par. 7.2.1).
Use a second battery or an
extended battery (par. 14.1).
Purchase a new battery.
Check it is correctly inserted
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual).
Clean the contacts.
Check it is plugged in and the
power socket is energised.
Replace with an original spare part
If the problem persists, refer to the battery
charger manual.
14.3 BATTERY BACKPACK
The device is used to place the two batteries
and provides the electrical power required
for the operation of the
It is provided with a cable used for the
connection to the machine (Fig. 1.G) and with
a selector (Fig. 7.B) used to disconnect the
power supply ("OFF" position) or to select one
of the two batteries (position "1" and "2").
EN - 16
SOLUTION
disconnect it
contact
(par. 7.2.3).
machine.