Caster/Caster Foot Assembly; Wet/Dry Vac Assembly - RIDGID 6000RV0 Manual Del Usuario

SP6936-1 ESF 6000RV0 RIDGID1_SP6936-1 1/16/15 2:37 PM Page 5

Caster/Caster Foot Assembly

1. Turn the dust drum upside down on
the floor.
2. Insert the caster feet into the bottom of
drum, as shown (4 places).
3. Push on the caster foot until the foot is
flush with bottom of the dust drum.
4. Insert the caster stem into the socket
of the caster foot, as shown
(4 places).
5. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will
swivel easily when positioning is
correct.
6. Turn the drum upright.

Wet/Dry Vac Assembly

1. Line up front of powerhead assembly
with Vacuum port located on the front
of the drum, as shown.
NOTE: Powerhead assembly must be
aligned with drum for proper attachment.
2. Place powerhead assembly on top of
drum.
3. Be sure powerhead assembly
completely covers the top of the drum
so leakage does not occur.
4. Push down on top of handles to cause
flexible locking tabs to hook onto the
drum lip.
5. Make sure that the locking tabs are
snapped into place as shown, to
prevent the lid from coming off.
6. To remove the powerhead assembly,
reverse above directions.
Caster
Foot
Dust
Drum
Hole
Flexible Locking
Tab Pulled Out
Flexible
Locking Tab
Flexible Locking Tab
(located under latch)
Push
Down to
Latch
Pull
Out to
Unlatch
Drum
5
Caster
Caster Stem
Caster Ball
Pin
Drum
Powerhead
Assembly