For your own safety, turn off power at fuse box or circuit breaker before trouble shooting your fan.
Some suggested remedies require the attention of a licensed electrician.
Trouble
1.FAN WILL
NOT START
2.FAN SOUNDS NOISY
3.FAN WOBBLES
EXCESSIVELY
4.NOT ENOUGH AIR
MOVEMENT
Trouble Shooting
!
Probable Cause
1. Fuse or circuit breaker blown.
2. Loose power line connections to the
fan, or loose switch wire connections
in the switch housing.
3. Reversing switch in neutral position.
4. Dead battery in remote control.
1. Blades not attached to fan.
2. Loose screws in motor housing.
3. Screws securing fan blade to motor
assembly are loose.
4. Lower housing support set screw
loose.
1. Setscrew in downrod support is loose.
2. Setscrew in downrod/hanger ball
assembly is loose.
3. Screws securing fan blade to motor
assembly are loose.
4. Hanger bracket and/or ceiling timber
batten is not securely fastened.
5. Fan blades out of balance.
WARNING
1. Check main and branch circuit fuses
or circuit breakers.
2. Check line wire connections to fan
and switch wire connections in the
switch housings.
CAUTION: Make sure main power is
turned off !
3. Make sure reversing switch position is
all the way to one side.
4. Replace with fresh battery.
1. Attach blades to fan before operating.
2. Check to make sure all screws in
motor housing are snug (do not over-
tighten).
3. Check to make sure the screws which
attach the fan blade to the motor
assembly are tight.
CAUTION: Make sure main power is
turned off !
4. Tighten set screw securely.
1. Tighten both setscrews securely in
downrod support.
2. Tighten the setscrew in the downrod/
hanger ball assembly.
3. Check to make sure the screws which
attach the fan blade to the motor
assembly are tight.
4. Tighten the hanger bracket screws to
the timber batten, and secure outlet
box.
5. Use the balancing kit supplied.
1. If possible, consider using a longer
downrod. (not included, you can buy
the longer downrod from fanimation.
com).
16
Suggested Remedy