Safety; General Safety Instructions; Instructions, Standards And Regulations; Appliance Description - Stiebel Eltron CNS 50-2 E Guía De Operación E Instalación

INSTALLATION

SAFETY

INSTALLATION
9. Safety
Only qualified contractors should carry out installation,
commissioning, maintenance and repair of the appliance.
9.1

General safety instructions

We guarantee trouble-free function and operational reliability
only if the original accessories and spare parts intended for the
appliance are used.
DANGER: Electrocution
If you mount the appliance on the wall, do so in such
a way that control equipment cannot be touched by
a person in the bath or shower.
CAUTION:
-Only fit the wall mounted appliance to a vertical
!
wall that is temperature-resistant to at least 185 °F
/ 85 °C.
-Observe the minimum clearances to adjacent object
surfaces (for minimum clearances see specification
chapter).
-Never install the appliance directly below a wall
socket.
-Ensure that the power cable is not in contact with
any appliance components.
9.2

Instructions, standards and regulations

Observe all applicable national and regional
regulations and instructions.
Observe the Building and Garage Regulations [or
local regulations].

10. Appliance description

10.1 Standard delivery

Wall mounting bracket (hooked into the appliance)
»
11. Installation

11.1 Installing the wall mounting bracket

You can use the wall mounting bracket as a template for wall
mounting; this ensures the required floor clearance.
Unhook the wall mounting bracket.
»
Place the centred wall mounting bracket level on the ground
»
and mark holes 1 and 2.
Lift up the wall mounting bracket so that its lower holes match
»
up with the markings you have just made on the installation
wall.
Mark holes 3 and 4 on the installation wall.
»
WWW.STIEBEL-ELTRON-USA.COM
1 2
a a a
Drill holes at all four markings. Secure the wall mounting bracket
»
with suitable materials (screws, rawl plugs) depending on the
type of wall. With the vertical slots, you can compensate for an
offset fixing hole.

11.2 Appliance installation

Hook the appliance by its slots in the back of the appliance on
»
to all four tabs of the wall mounting bracket simultaneously.
Push the appliance to latch it in position.
»
Turn the locking bolt in the wall mounting bracket fully clockwise;
»
this locks the appliance in place.
Push the safety cap onto the locking bolt to prevent it from
»
loosening.
1 Locking bolt
2 Wall mounting bracket
3
4
1
2
CNS E / CNS 24H| 7