Briggs & Stratton Elite Serie Instrucciones De Uso página 12

How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun, nozzle extension and ProjectPro™
nozzles.There is also a hook at the front of the accessory
tray to hold your high pressure hose.
NOTE: The extra hole in the tray is for storing a utility
brush.The extra clip in the tray is for storing a turbo
nozzle.The brush and turbo nozzle are NOT included with
your pressure washer.You can buy these items as optional
accessories.
1. Place nozzle extension through hole on accessory tray,
as shown in Figure 12.
Figure 12 — Typical Accessory Tray
2. Place spray gun through hole on accessory tray on
right side of unit (Figure 12).
3. Insert multi–colored ProjectPro™ nozzles in spaces
provided in accessory tray (Figure 12).
4. Hang high pressure hose on hook attached to accessory
tray on front of tray, as shown in Figure 12.
2550 PSI Pressure Washer
How to Use ProjectPro™ Nozzle
System
The quick–connect on the nozzle extension allows you to
switch between four different ProjectPro™ system nozzles.
The ProjectPro™ nozzles vary the pressure and spray
pattern as shown (Figure 13).
Figure 13 — Nozzle Spray Patterns
Delicate
40° Yellow
1750 PSI
2.3 GPM
Follow these instructions to change ProjectPro™
nozzles:
1. Engage trigger lock on spray gun.
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
• NEVER exchange ProjectPro™ nozzles without locking the
trigger lock on the trigger.
• DO NOT twist ProjectPro™ nozzles while spraying.
2. Pull back collar on quick–connect and pull current
ProjectPro™ nozzles off. Store ProjectPro™ nozzles in
holder provided on the accessory tray.
12
Low Pressure
Black
Use to apply
detergent
High Pressure
General
0° Red
15° Orange
2550 PSI
2200 PSI
2.0 GPM
2.2 GPM
CAUTION
Max