2.
Insert carriage bolts through holes from outside of the
unit and attach a plastic knob from inside of unit
(Figure 2).Tighten by hand.
Figure 2 — Secure Handle
3.
Place accessory tray over holes on handle (viewing
from front of unit). Push the tree clips into the holes
until they sit flat against the accessory tray (Figure 3).
Figure 3 — Attach Accessory Tray to Handle
2550 PSI Pressure Washer
4.
Insert multi–colored ProjectPro™ nozzles and other
supplied accessories in spaces provided in accessory
tray. See "How to Use Accessory Tray".
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine operator's manual for oil and fuel fill
information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine operator's manual for recommendations.
8
CAUTION