Publicidad
Idiomas disponibles
Idiomas disponibles
MESURES D'INSTALLATION
Le robinet et les drainages du bidet doivent être achetés séparément.
La dimension de l'installation et la performance hydraulique répondent ou
dépassent tous les standards ANSI/ASME A112.19.2 et les requis
CAN/CSA B45.
10
1
INSTALLATION PREPARATION
Turn-off water supply and if necessary remove the old bidet.
Install or relocate the supply tubing and waste pipe to the specified
rough-in dimension.
2
INSTALLATION OF THE BIDET
Set the bidet on the desired installation location and mark the position
of the mounting holes.
Remove the bidet and drill 3/16" holes in the center of the marked location.
Thread the floor bolts (included) into the mounting holes. Use anchors
as necessary.
Place the bidet over the mounting bolts so that both of the bolts extend
through the bidet mount holes behind the skirt.
Install washer and nuts. Hand-tighten nuts first, then tighten additional
1/2 turn with wrench.
!
DO NOT OVERTIGHTEN the screws. May damage the products
and cause personal injury and/or property damage
Warning
3
FINISHING THE INSTALLATION
Install the faucets and drain per manufacturer's instructions.
Turn-on the water supply and check entire installation for leaks.
Fig. 1 BT930 - Back View
3
Publicidad
