Maintenance & Servicing - HOLL'S Hybrid Combi Manual De Instalación

Maintenance & servicing
Maintenance
IMPORTANT:
Disconnect the cabin's power supply cable before undertaking any work.
Problems identified
No indicator light displayed
on the control panel.
One or more infrared panels
do not heat up.
Sauna gives off a smell.
Sauna light fitting no longer
work.
A speaker is not working.
MP3 player not working.
Screen shows a wrong temperature.
Servicing
1. Disconnect your sauna.
2. Use a vacuum cleaner to remove dust from crevices in the woodwork.
3. Clean the cabin with a damp cotton cloth and use a small amount of soap if necessary. Rinse with a damp cloth.
4. Clean the glass with a window / glass cleaner and a soft colth.
5. Please check and fasten the screws of the bench once every three months to prevent the play or fall of the seat.
IMPORTANT:
Do not use benzene, alcohol, chemical agents or strong detergents on the sauna since chemical products can damage the
wood. Do not spray water on your sauna.
14
Possible reasons
Power supply cable disconnected.
The general power supply is cut.
Fault in power supply unit.
The infrared panel button is
positioned to the middle (
The infrared panel's cable is
disconnected.
One of the infrared panels is
defective.
Temperature of the panels or their
cables is too high.
Ribbon LED cable not fully plug.
Ribbon LED is defective.
Speaker cable disconnected.
Speaker defective.
Power supply cable disconnected.
MP3 player not switched on.
Temperature sensor is incorrectly
connected or defective.
Solutions
Check power supply cable connection.
Check that the switchboard and wall plug
are working.
Contact your dealer.
Push the button panel to the right or left
according to your desire.
).
Check cable connections.
Replace the infrared panel with an original
component supplied by the manufacturer.
Switch off power supply and contact your
dealer.
Plug the cable.
Contact your dealer.
Reconnect the cable.
Contact your dealer.
Reconnect power supply cable.
Check the DC power supply cable and
replace if required.
Reconnect the cable or replace the
sensor.