Optional Module Description - WEG SSW-08 Guia De Instalacion

1. DESCRIPTION OF THE KIT
Contents:
SSW-08 Remote Keypad kit (Part number: 10885878)
Quantity
1
1
2. SAFETY NOTICES
ATTENTION!
Switch off the Soft-Starter SSW-08 before installing the Remote Keypad
kit.
The electronic boards have components that are susceptible to
electrostatic discharge. Never touch any of the electrical components
or connectors without following the proper grounding procedures. If it
is necessary to do so, touch the grounded heatsink or use a suitable
grounded wrist strap.
3. DEGREE OF PROTECTION
IP54 - NEMA 12 (mounted in the door of the panel) shown in figure 2.

4. OPTIONAL MODULE DESCRIPTION

The Remote Keypad is mounted externally to the Soft-Starter, with a cable
length up to 10 m (33 ft), on the panel door or command console.
The Remote Keypad Interface is used exclusively for the connection of the
Remote Keypad to the Soft-Starter. It is fitted into the front cover slot for
optional plug-in modules.
The cable used to connect the Remote Keypad to the Soft-Starter is an option
and is available in sizes of 1 m (3.3 ft), 2 m (6.6 ft), 3 m (9.8 ft), 5 m (16.4 ft),
7.5 m (25 ft) and 10 m (33 ft).
NOTE!
The Remote Keypad does only work together with the Remote Keypad
Interface and the appropriated cable.
Table 1 - Contents of the Kit
Description
Remote Keypad connection optional module
Remote Keypad
3