Sangean ProTravel PT 80 Instrucciones De Manejo página 9

Ocultar thumbs Ver también para ProTravel PT 80:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

02 Yacht Boy 80, GB
8
19.08.2003
14:52 Uhr
SETTINGS
___________________________________________________
Setting and storing radio stations
There are various ways to set radio stations and store them at preset positions.
1
ON/OFF SLEEP
Press »
– You will hear the radio station last selected.
2
BAND
Press »
« to select the frequency band.
Tuning radio stations directly
1
FREQ./CLOCK
Press »
– Display: »
«, e.g. »
– –.– –
2
Enter the frequency using the numerical buttons »
for example 1, 0, 0, 6 for »
3
FREQ./CLOCK
Press »
– Display: the frequency you entered, for example »
– You will hear the selected radio station.
Tuning radio stations manually (1)
1
TUNING FINE
Use the »
– Display: the frequency in 100 or 200 kHz increments (FM), in 9 or
10 kHz increments (MW), in 3 kHz increments (LW) or in 5 kHz incre-
ments (SW).
2
If you want, you can fine tune to the station by briefly pushing in and
TUNING FINE
turning the »
– Display: The frequency changes in 50 kHz increments (FM) or 1 kHz
increments (MW, LW and SW).
3
To return to the original mode (for example 100 kHz increments in the
FM band) push in the »
Tuning radio stations manually (2)
1
Keep pressing » « or » « until you reach the frequency you want.
– Display: the frequency changes in increments
or
Hold down » « or » « until the frequency changes to a rapid run-
through.
– Display: the automatic search stops at the next station with a strong
signal.
Saving radio stations on preset positions
You can store up to 45 radio stations, including 18 on two memory levels
on short wave, and nine each on FM, MW and LW.
1
Select the frequency band and the radio station.
Seite 28
« to switch on the device.
«.
« and »
« flash.
FM
MHz
1 ... 0
«.
100.60
« to confirm the entry.
« dial to tune to the station you want.
« dial.
TUNING FINE
« dial again.
« in four digits,
«.
100.60

Publicidad

Tabla de contenido
loading

Tabla de contenido