Step2: Connect The Speakers - Pioneer ELITE VSX-LX302 Manual Del Usuario

> Before Start > Part Names

Step2: Connect the Speakers

a
a Speaker cable, b Subwoofer cable
> Install > Initial Setup
1/2˝
(12 mm)
b
> Playback
Standard Connections (Pages 8 to 12)
Connect 12345678 for a 7.1 channel system.
Connect 1234569: for a 5.1.2 channel system. Up
to two powered subwoofers can be connected. The same
signal is output from each of the SUBWOOFER PRE OUT
jacks.
0 You can also connect both 78 and 9:. However, you can
only output audio from one of these at a time. When both
are connected, you can switch which speakers to prioritize.
Press on the remote control (P6) and use "Other" -
"Speakers" to switch between surround back speakers and
height speakers and to switch speakers A and B.
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. Full Auto
MCACC" in Initial Setup (P23).
0 If any of the connected speakers have an impedance of
4 Ω or more to less than 6 Ω, after completing Initial
Setup, you need to make some settings in the System
Setup menu. Press
the Home displayed set "System Setup" - "Speaker" -
"Configuration" - "Speaker Impedance" to "4ohms".
OR
Speaker B
Make sure the exposed wires of the speakers do
not stick out of the speaker terminals when
connecting. If the exposed wires of the speakers
touch the rear panel or the + and – wires touch
each other, the protection circuit will be activated.
on the remote controller, and in
En 15