Dri-Eaz 1200 115V Manual Para El Usuario página 5

F A U L T
Unit does not No power to machine.
operate Unit not switched on.
Not enough time to dry.
Unit operating,
Poor air movement in room.
but room not dry
Excessive moist air infiltration.
Unit Room temperature too low
continuously in
defrost mode
Pump does not Stuck float valve
function
Unit collects too Room air is dry.
little water Room temperature is too low.
If the problem you are experiencing is not listed here, call your local distributor or contact the Dri-Eaz Service
Department toll-free at 800-932-3030.
SPECIFICATIONS
Model DrizAir 1200 F203-A
Type Standard refrigerant
Refrigerant R-410A
Use weight 80 lbs. | 36 kg
Dimensions 32 × 20 × 19.5 in.
(H × D × W) 83 × 50 × 50 cm
Power 6.4 amps, 115 volts
Water removal AHAM
64 pts. | 30 liters / day
(80°F/60% RH)
Water removal max.
132.3 pts. | 62.6 liters / day
(90°F/90% RH)
Max process air 235 CFM | 400 CMH*
Operating range 33°–100°F | 1°–38°C
Air filter 3M HAF filter (part no. F368)
Power cord 25 ft. | 7.6 m
Construction Rotomolded polyethylene housing
Safety ETL listed CSA 22.2 no. 92
Specifications are subject to change without notice. Some
values may be approximate.
07-01705B 2014-04 Warranty 07-00420
C A U S E
Plug in unit; check power at outlet and at base of unit.
Switch unit on.
Allow more time for drying.
Increase air movement with air movers.
Reduce infiltration.
Increase room temperature.
Clean float valve shaft.
Check humidity with hygrometer.
Increase room temperature.
Check filter and coils; clean as necessary.
S O L U T I O N
Warranty information is available at www.dri-eaz.com.
CONTACT
Dri-Eaz Products, Inc.
15180 Josh Wilson Rd.
Burlington, WA 98233
800-932-3030 www.dri-eaz.com
5 Dri-Eaz Products, Inc.