Metabo HPT DV16V Manual De Instrucciones página 10

English
9. Check the rotational direction (Fig. 5)
The bit rotates clockwise (viewed from the
rear side) by pushing the R-side of the push
button.
The L-side of the push button is pushed to
turn the bit counterclockwise.
(The and
L R
body.)
CAUTION:
Never change the direction of bit rotation while operating. Turn the power switch OFF
before changing the direction of bit rotation: otherwise, burning of the motor will
result.
Always use the hammer drill with clockwise rotation, when using it as an hammer
drill.
10. Fixing the side handle (Fig. 6)
Attach the side handle to the mounting part.
Rotate the side handle grip in a clockwise direction to secure it.
Set the side handle to a position that is suited to the operation and then securely tighten
the side handle grip.
To attach a depth gauge on the side handle, insert the gauge into the U-shaped groove
on the side handle, adjust the position of the depth gauge in accordance with the desired
depth of the hole, and firmly tighten the side handle grip. (Fig. 7)
Side handle
Loosen
10
marks are provided on the
Tighten
Fig. 6
Push button
L
mark
L
R
mark
R
Fig. 5
Depth gauge
Side handle
Loosen
Fig. 7
Switch trigger
Tighten