Indicator Lamp; Side Handle; Torque Limiter - Makita HR4001C Manual De Instrucciones

For long time hammering (FOR MODELS HR4001C
AND HR4010C ONLY)
3
HR4001C
HR4010C
► 1. Change lever 2. Pointer 3. Lock button
For chipping, scaling or demolition operations, depress
the lock button and rotate the change lever so that the
pointer points to the symbol. Use a bull point, cold
chisel, scaling chisel, etc.
CAUTION:
• When using the tool in the
switch trigger does not work and only the slide
switch works.
FOR MODEL HR4011C
3
► 1. Change lever 2. Pointer 3. Lock button
For chipping, scaling or demolition operations, depress
the lock button and rotate the change lever so that the
pointer points to the symbol. Use a bull point, cold
chisel, scaling chisel, etc.
CAUTION:
• Do not rotate the change lever when the tool is
running under load. The tool will be damaged.
• To avoid rapid wear on the mode change mech-
anism, be sure that the change lever is always
positively located in one of the two or three
action mode positions.

Torque limiter

The torque limiter will actuate when a certain torque
level is reached. The motor will disengage from the out-
put shaft. When this happens, the bit will stop turning.
2
1
symbol mode, the
HR4011C
2
1
6 ENGLISH
CAUTION:
• As soon as the torque limiter actuates, switch
off the tool immediately. This will help prevent
premature wear of the tool.

Indicator lamp

1
2
► 1. Power-ON indicator lamp (green) 2. Service
indicator lamp (red)
The green power-ON indicator lamp lights up when the
tool is plugged in. If the indicator lamp does not light up,
the mains cord or the controller may be defective. The
indicator lamp is lit but the tool does not start even if the
tool is switched on, the carbon brushes may be worn
out, or the controller, the motor or the ON/OFF switch
may be defective.
The red service indicator lamp lights up when the car-
bon brushes are nearly worn out to indicate that the tool
needs servicing. After approx. 8 hours of use, the motor
will automatically be shut off.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.

Side handle