How To Operate - Easy Home HTJ-2060B Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

How to operate

1.
Lift water tank off of base holding bottom of tank with both hands.
2.
NOTE: DO NOT hold water tank by handle when empty or full.
3.
Turn tank upside down and unscrew water tank cap by turning it counterclockwise.
4.
Fill water tank with cold water. Do not fill all the way to the rim.
5.
NOTE: If you have hard water, it is recommended to use filtered or distilled water.
While using the humidifier, if you see a film of white dust, it is because of hard water.
6.
DO NOT add any medication or other additives into the water tank itself. For use of
essential oils, see page 11.
7.
Screw water tank cap back onto tank by turning clockwise.
8.
Place tank onto the base. Make sure it is laying flush into the base. There should not
be a space between the tank and base.
9.
Place mist lid on top of water tank and turn mist lid to face desired direction of the
mist.
10. NOTE: DO NOT move humidifier while water tank is on base. Water may leak into the
base causing a malfunction.
11. Plug the power cord into an electrical outlet. DO NOT use an extension cord.
12. Turn power on by turning the knob clockwise (to the right). You will hear a minor
clicking noise when turning unit on and off. The green power indicator light will turn
on.
13. In a few moments, the mist will start coming through the mist lid. Use the control
knob to adjust the intensity of the mist output. Turning the knob clockwise will
increase the moisture output, turning the knob counterclockwise will reduce the
moisture output.
14. Note: When at maximum level it is normal to hear a faint dripping sound.
15. Turn on the blue LED light by pressing the 'LED On/Off' button in. To turn it off, press
the button again.
16. When the humidifier runs out of water the power light will turn red, and the mist
output will stop. This is a safety feature to prevent the humidifier from possibly
overheating and damaging the nebulizer. This safety feature uses a water level sensor
to stop the nebulizer once the water level sinks below the required level in the water
basin.
17. Turn the humidifier off and unplug before removing and refilling the water tank.
10
User instructions

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido